Filter
Top Products
27
Editing Recorded MDs
Undoing the Last Edit
(Undo Function)
You can use the Undo Function to cancel the last edit
and restore the contents of the MD to the condition that
existed before editing was done. Note, however, that
you cannot undo an edit if you do any of the following
after the edit:
• Press the r button on the front panel.
• Press the r button, the MUSIC SYNC button, or the
CD-SYNC STANDBY button on the remote.
• Turn off the power or eject the MD.
• Disconnect the AC power cord.
1 While the recorder is stopped or during playback
pause, press EDIT/NO to display “Edit Menu.”
2 Turn AMS until “Undo?” appears in the display,
then press AMS.
“Undo?” does not appear if no editing has been
done.
One of the following messages appears in the
display, depending on the type of editing to be
undone:
Editing done:
Erasing a single track
Erasing all tracks on an MD
Dividing a track
Combining tracks
Moving a track
Labeling a track or an MD
Changing an existing title
Message:
“Erase Undo ?”
“Divide Undo ?”
“Combine Undo ?”
“Move Undo ?”
“Name Undo ?”
3 Press YES again.
“Complete” appears for a few seconds and the
contents of the MD are restored to the condition
that existed before the edit.
To cancel the Undo Function
Press EDIT/NO or p.
EDIT/NO YES≠AMS±
Function of Control Terminal
Control terminal (CTRL-S)
Mini jack type
When a system controller with CTRL-S terminal is
connected to the control terminal of this recorder,
it can operate as a remote .
Control functions
The system controller which is connected to the control
terminal operates the same as the supplied remote
RM-D7M.
Note
When the system controller is connected to the control
jack, the remote can not be used because its infrared
rays are stopped.
Additional Information