Filter
Top Products
25
Editing Recorded MDs
7
Repeat Steps 4 to 6 until you have entered the
entire title.
If you entered the wrong character
Press 0 or ) until the character to be corrected starts
flashing, and repeat Steps 4 to 6 to enter the correct
character.
To erase a character
Press 0 or ) until the character to be erased starts
flashing, then press EDIT/NO.
To enter a space
Press AMS or ) while the cursor is flashing.
8 Press YES.
This completes the labeling procedure and the
title appears on the left side of the display.
To cancel labeling
Press p.
Note
You cannot label a track or an MD while you are recording
over an existing track.
4 Press DISPLAY/CHAR to select the character
type as follows:
5 Turn AMS to select the character.
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
! ” # $ % & ’ ( ) * + , – . / : ; < = > ? @ _ ` ^
You can press DISPLAY/CHAR to change the
character type at any time during this step (see
Step 4.)
6 Press AMS to enter the selected character.
The cursor shifts rightward and waits for the
input of the next character.
To select
Press DISPLAY/CHAR repeatedly
until
Uppercase letters
“A” appears in the display
Lowercase letters
“a” appears in the display
Numbers
“0” appears in the display
(Continued)