Filter
Top Products
54
Specifications
For the U.S. model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6 ohm loads, both channels driven, from
120 – 10,000 Hz; rated 110 watts per channel
minimum RMS power, with no more than
10% total harmonic distortion.
Center Speaker:
Continuous RMS power output (Reference)
45 watts
(8 ohms at 1 kHz, 10%
THD)
Rear Speaker:
Continuous RMS power output (Reference)
45 + 45 watts
(8 ohms at 1 kHz, 10%
THD)
LBT-LX9AV
Front Speaker:
DIN power output (Rated)
90 + 90 watts
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (Reference)
120 + 120 watts
(6 ohms at 1 kHz, 10%
THD)
Music power output (Reference)
200 + 200 watts
(6 ohms at 1 kHz, 10%
THD)
Center Speaker:
DIN power output (Rated)
30 watts
(8 ohms at 1 kHz, DIN)
Continuous RMS power output (Reference)
40 watts
(8 ohms at 1 kHz, 10%
THD)
Music power output (Reference)
60 watts
(8 ohms at 1 kHz, 10%
THD)
Rear Speaker:
DIN power output (Rated)
30 + 30 watts
(8 ohms at 1 kHz, DIN)
Continuous RMS power output (Reference)
40 + 40 watts
(8 ohms at 1 kHz, 10%
THD)
Music power output (Reference)
60 + 60 watts
(8 ohms at 1 kHz, 10%
THD)
•The tab has been removed from the
cassette (see page 51).
•The tape has reeled to the end.
The tape does not record nor play, or there
is a decrease in sound level.
•The heads are dirty. Clean them (see page
52).
•The record/playback heads are
magnetized. Demagnetize them (see page
52).
The tape does not erase completely.
•The record/playback heads are
magnetized. Demagnetize them (see page
52).
There is excessive wow or flutter, or the
sound drops out.
•The capstans or pinch rollers are dirty.
Clean them (see page 52).
Noise increases or the high frequencies are
missing.
•The record/playback heads are
magnetized. Demagnetize them (see page
52).
Tuner
Severe hum or noise (“TUNED” or
“STEREO” flashes in the display).
•Adjust the antenna.
•The signal strength is too weak. Connect
an external antenna.
A stereo FM program cannot be received in
stereo.
•Press STEREO/MONO so that “STEREO”
appears in the display.
If other problems not described
above occur, reset the system as
follows:
1 Unplug the power cord.
2 Plug the power cord back in.
3 Press c/CLOCK SET, ENTER, and
?/1 at the same time.
The system is reset to the factory settings. All
the settings you made, such as the preset
stations, clock, and timer are cleared. You
should set them again.
Troubleshooting (continued)