Filter
Top Products
11
Saving power in
standby mode
(For LBT-LX90AV/
LX9AV only)
In standby mode, you can reduce the power
consumption to a minimum (Power Saving
mode) and save energy in standby mode.
POWER SAVE/DEMO
(STAND BY)
DISPLAY
, Press POWER SAVE/DEMO
(STAND BY) while the system is
turned off.
The system switches to the Power Saving
mode and the clock display disappears.
The system is turned on/off by pressing
?/1.
To cancel the Power Saving mode
Press DISPLAY.
The clock display reappears.
?/1
(Power)
To erase a preset number
1 Press and hold TUNER MEMORY until a
preset number flashes in the display.
2 Press TUNING +/– to select the preset
number you want to erase. Select “ALL
ERASE” to erase all preset numbers.
3 Press ENTER/NEXT.
When you erase a preset number, all the
following preset numbers shift up and reduce
by one.
To change the AM tuning interval
(Except for European and Middle
Eastern models)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval to 10 kHz (or 9 kHz), press TUNER/BAND
repeatedly until “AM” appears, then turn off the
system. While holding down ENTER, turn the
system back on. When you change the interval, the
AM preset stations will be erased. To reset the
interval, repeat the same procedure.
Note
The preset stations are canceled when you
disconnect the power cord or if a power failure
occurs for more than half a day.
continued