Sony DH840 Stereo Receiver User Manual


 
17
GB
D:\NORM'S JOB\SONY HA\SO0190\STR-DH730_DH830_PMRF
01\4408151112_GB\GB04GET_STR-DH730-CEL.fm
masterpage: Right
STR-DH830/STR-DH730
4-408-151-11(2)
Getting started
You can enjoy your audio/video equipment connected to the receiver by following the simple steps
below.
Before connecting cords, be sure to disconnect the AC power cord (mains lead).
Installing and connecting the
speakers (page 18, 20)
Checking the connection
appropriate for your equipment
Connecting the TV and video
equipment (page 22, 23)
The image quality depends on the connecting
jack. See the illustration below. Select the
connection according to the jacks on your
equipment.
We recommend that you connect your video
equipment via HDMI connection if they have
HDMI jacks.
Connecting the audio equipment
(page 30)
Preparing the receiver
See “6: Connecting the AC power cord (mains
lead)” (page 31) and “Initializing the receiver”
(page 32).
HDMI
VIDEO
COMPONENT VIDEO
Y
P
B
/C
B
P
R
/C
R
Analog
High quality image
Digital
Setting the speakers
Select the speaker pattern (page 32), then perform
Auto Calibration (page 33).
Note
You can check the speaker connection using
“Test Tone” (page 64). If the sound is not output
correctly, check the speaker connection.
Setting the audio output settings on
the connected equipment
To output multi channel digital audio, check the
digital audio output setting on the connected
equipment.
For a Sony Blu-ray Disc player, check that
“Audio (HDMI)”, “Dolby Digital”, and “DTS”
are set to “Auto”, “Dolby Digital” and “DTS”
respectively (as of September 2011).
For a PlayStation 3, check that “BD/DVD Audio
Output Format (HDMI)” and “BD Audio Output
Format (Optical Digital)” are set to “Bitstream”
(with system software version 3.70).
For details, refer to the operating instructions
supplied with the connected equipment.