Filter
Top Products
Getting Started
21
GB
Notes
• Make connections securely to prevent unwanted noise.
• Refer to the instructions supplied with the TV.
• The system cannot output an audio signal to the connected TV. Only the audio signal of the TV is output from the
system speakers.
Setup for the system (for Asian, Australian, and Saudi Arabian
models)
Setup is necessary for the system, depending on the TV to be connected.
The factory setting for Australian and Saudi Arabian models are PAL.
The factory setting for Asian models is NTSC.
If the colour system of the TV is NTSC*
To set the system to NTSC, turn on the system by pressing "/1 while pressing the X button on the
system. You need to hold the X button until “HELLO” appears on the display. To reset to PAL, turn
off the system and then turn on again using the remote while press and hold the X button on the system,
and turn the system off and then on again.
* If the colour system of the TV is PAL, do the same operation above to set the system to PAL.
When connecting to a standard 4:3 screen TV
Depending on the disc, the image may not fit your TV screen.
If you want to change the aspect ratio, please refer to page 65.
R
AUDIO
OUT
L
VIDEO
IN
INPUT
Y
P
B/CB
PR/CR
COMPONENT
VIDEO IN
S VIDEO
IN
INPUT
OUTPUT
Y
P
B
/C
B
P
R
/C
R
S
VIDEO
VIDEO
(
DVD ONLY
)
AUDIO IN
FRONT R
SURR R SURR LWOOFER
CENTER FRONT L
L
R
MONITOR OUT
COMPONENT VIDEO OUT
VIDEO/SAT
SPEAKER
COAXIAL
AM
FM
75
INOUT
IN
IN
TV
VCR or Digital
satellite receiver
TV with COMPONENT
VIDEO IN jacks
TV with S VIDEO jack
continued