Filter
Top Products
22
Recording tips (continued)
No sound input for less than 30 seconds
No sound input for 30 seconds or more
To change the trigger level for Level
Synchro Recording
Perform the following procedure to change the
signal level that triggers Level Synchro
Recording.
1 Press FUNCTION repeatedly to switch the
function to MD.
2 Press MENU/NO on the remote repeatedly
until “Setup Menu” appears.
3 Press . or > for the MD until “LS(T)”
appears, then press ENTER/YES on the
remote.
4 Press . or > for the MD to select the
level, then press ENTER/YES on the
remote.
You can set the level at any value between
–72 dB and 0 dB, in 2 dB steps.
5 Press MENU/NO on the remote.
Marking track numbers at a specific
point during recording
— Track Mark
You can mark track numbers at any time during
manual recording, regardless of the type of
sound source.
Press MD REC z during manual recording at
the point you want to add a track mark.
The tracks following the added one are
renumbered.
Making a space between
tracks 3 seconds long
— Smart Space
Smart Space: Lets you make the blank
spaces between tracks 3 seconds long
automatically while recording. If the Smart
Space function is on and there is no sound
input for about 3 seconds or more (but less than
30 seconds) while recording, the MD deck
replaces this silence with a blank of about 3
seconds and continues recording.
Replaced with a blank of 3 seconds and
recording continues
Auto Cut: When the Smart Space function is
on, if there is no sound input for 30 seconds or
more, the MD deck replaces this silence with a
blank of about 3 seconds and enters recording
pause.
Replaced with a blank of 3 seconds and
recording pauses
Off
On
Off
On