Filter
Top Products
8
Setting the time
1 Turn on the system.
2 Press CLOCK/TIMER SET on the
remote.
If you are setting the clock for the first time,
go to step 5.
3 Press – or + (. or >) on the
remote repeatedly until “CLOCK SET?”
appears in the display.
4 Press ENTER/YES on the remote.
The day indication flashes.
5 Press – or + (. or >) on the
remote repeatedly to set the day, and
then press ENTER/YES or CURSORt
on the remote.
The hour indication flashes.
6 Press – or + (. or >) on the
remote to set the hour, and then press
ENTER/YES or CURSORt on the
remote.
The minute indication flashes.
7 Press – or + (. or >) on the
remote repeatedly to set the minute,
and then press ENTER/YES on the
remote.
If you made a mistake
Press TCURSOR or CURSORt on the
remote until the indication you wish to change
(day, hour, minute) flashes, and then change
the setting.
To reset the time
Start over from step 1.
Conserving power in
standby mode
Even if the system is off, the unit consumes
power to power the clock and to stay
responsive to commands from the remote.
Power saving mode was introduced to reduce
the amount of power consumed during standby.
In this mode, the clock or demonstration is not
displayed.
To change to power saving mode, press
DISPLAY or TIME on the remote
repeatedly while the system is off until
demonstration mode and the clock
disappear from the display.
To change the display
Press DISPLAY or TIME on the remote
repeatedly while the system is off.
The display changes as follows:
Clock display* t Demonstration mode** t
Power saving mode t Clock display* t …
* After about 8 seconds, the system returns to power
saving mode.
**The indications in the display and lamps on several
buttons light up or flash even after the system is
turned off.
Tip
The timer continues to operate during power saving
mode.