Filter
Top Products
25
MD — Recording
Making a space between
tracks 3 seconds long
— Smart Space
Smart Space: Lets you make the blank
spaces between tracks 3 seconds long
automatically while recording. If the Smart
Space function is on and there is no sound
input for about 3 seconds or more (but less than
30 seconds) while recording, the MD deck
replaces this silence with a blank of about 3
seconds and continues recording.
Replaced with a blank of about 3 seconds
and recording continues
Auto Cut: When the Smart Space function is
on, if there is no sound input for 30 seconds or
more, the MD deck replaces this silence with a
blank of about 3 seconds and enters recording
pause.
Replaced with a blank of about 3 seconds
and recording pauses
continued
No sound input for less than 30 seconds
Off
On
No sound input for 30 seconds or more
Off
On
To change the trigger level for
automatic track marking
Do the procedure below to change the signal
level that triggers automatic track marking.
(The factory setting is –50 dB.)
1 Press MENU/NO on the remote during
recording pause to display “Setup?”, and
then press ENTER/YES on the remote.
2 Press . or > repeatedly until “LS(T)”
appears, and then press ENTER/YES on
the remote.
3 Press . or > repeatedly to select the
level, and then press ENTER/YES on the
remote.
You can set the level at any value between
–72 dB and 0 dB, in 2 dB steps.
4 Press MENU/NO on the remote.
To cancel automatic track marking
Press . or > repeatedly until “T.Mark
Off” appears in step 5 of the left column, and
then press ENTER/YES on the remote.
“L-SYNC” disappears. When “L-SYNC” is
off, a track number is marked only at the
beginning of each recording.
Marking track numbers at a specific
point during recording
— Track Mark
You can mark track numbers at any time when
recording to an MD from the tuner or from an
optional component connected to the TAPE IN
or DIGITAL OPTICAL IN jack, regardless of
the type of sound source.
Press REC/REC IT during recording at the
point you want to add a track mark.