Filter
Top Products
58
Troubleshooting (continued)
The sound skips.
• Wipe the CD clean (see page 55).
• Replace the CD.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the system,
or placing them on separate stands.
When you listen to a track with bass sounds at
high volume, the speaker vibration may cause the
sound to skip.
Play does not start from the first track.
• Press PLAY MODE on the remote repeatedly
until “PROGRAM” or “SHUF” disappears to
return to normal play.
“—OVER—” appears.
• Press and hold m or press . to return to the
desired playing position.
MD Deck
An MD cannot be loaded.
• Load the MD with the arrow side up and the
arrow pointing toward the deck.
The controls do not work.
• Replace the MD with a new one.
• Retry the operations after “TOC” turns off.
Play does not start.
• Replace the MD.
• Insert the MD and leave the system turned on for
a few hours until the moisture evaporates.
• Press NX to start play.
• You cannot use the Group function when there
are no group tracks.
Press GROUP ON/OFF to turn off “GROUP.”
The timer does not function.
• Press CLOCK/TIMER SELECT on the remote
and light up “cDAILY” or “cREC” in the
display (see pages 47 and 48).
• Check the set contents and set the correct time
(see page 8 or 46 to 49).
• Cancel the Sleep Timer function (see page 45).
• You cannot activate Daily Timer and recording
timer at the same time.
• After you have set the timer, make sure to press
`/1 to turn off the system.
• The system is on about 30 seconds before the
preset time.
The remote does not function.
• Remove the obstacle.
• Move the remote closer to the system.
• Point the remote at the system’s sensor.
• Replace the CR2025 battery.
• Locate the system away from the fluorescent
light.
CD Player
The CD does not eject.
• Press and hold CD Z.
• Consult your nearest Sony dealer.
Play does not start.
• Load a CD.
• Wipe the CD clean (see page 55).
• Replace the CD.
• The CD is loaded with the label side down. Load
the CD correctly.
• Remove the CD and wipe away the moisture on
the CD, then leave the system turned on for a
few hours until the moisture evaporates.
• Press NX to start play.