Filter
Top Products
14
CDP-CE575
ADJ MODE
NOTE: This mode cannot be performed without a general remote com-
mander.
1. Chuck the CD first, and then turn OFF the power.
2. Short-circuit the test point TP (ADJ) of the MAIN board and
ground with a lead wire.
3. Press the [POWER] button to turn ON the power.
The CD is playback the 2nd track automatically and the ADJ
mode is set.
4. To exit the mode, press the [POWER] button to turn OFF the
power.
ADJ Mode Special Function Table
Button Function
DISC 1 RFDC display
DISC 2 Decision of Disc size (8/12 cm)
DISC 3 Change the slice level
DISC 4 Change the focus bias (high/middle/low)
DISC 5 Track jump (1st y 20th)
TIME/TEXT TRK off/on
M Offset (VC), EF bias display
m Offset (RF, FE, TRK) display
EX-CHANGE Focus bias down
DISK SKIP Focus bias up
X-FADE Track gain up/down
EDIT Disc kind (aluminum/RW), side (8/12 cm) display
CHECK S-curve mode
CLEAR RFCK t GFS t error rate display
PEAK SERCH Best point of focus bias, jitter value display
FADER Auto gain display
SECTION 5
TEST MODE
FLUORESCENT INDICATOR TUBE, LED ALL LIT,
AND KEY CHECK MODE
1. Short-circuit the test TP (AFADJ) of the MAIN board and
ground with a lead wire.
2. Press the [POWER] button to turn ON the power.
The whole fluorescent indicator tube lights up.
3. All buttons have individual button numbers.
When a button is pressed, the button number is counted up
and displayed.
When remote controller signals are received, “RM **” will be
displayed.
(** are the numbers corresponding to the remote controller
buttons)
When using the remote controller, switch the [CD1/2/3] switch
to CD1.
4. To exit the mode, press the [POWER] button to turn OFF the
power.
button number Displays button numbe
r
10
Connecting Location:
– MAIN BOARD (Component Side) –
TP (AFADJ)
TP (ADJ)
R301