Filter
Top Products
47
GB
D:\NORM'S JOB\SONY HA\SO0056\STR-DA3500ES\CEL VERSION\GB\4144907431\01GB-
STRDA3500ESUC\030CON_GB.fm
masterpage: Right
STR-DA3500ES
4-144-907-43(1)
Getting Started
8 The measurement starts in five
seconds.
9 Measurement starts.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• In the following situations, the measurements have
not been performed correctly or Auto Calibration
cannot be performed.
– when connecting special speakers, such as
dipole speakers.
– when using the zone 2/zone 3 function in
zone 2/zone 3.
To cancel the measurement
The measurement will be canceled when you
do the following:
–Press ?/1, input buttons or MUTING.
– Press SPEAKERS (OFF/A/B/A+B) on the
receiver.
– Change the volume level.
– Connect the headphones.
– Press GUI MODE.
1 Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the TV screen.
Note
When the speaker(s) is (are) out of the phase,
“Out Phase” is displayed on the TV screen.
The “+” and “–” terminals of the speaker may
be connected the other way around. However,
depending on the speakers, “Out Phase”
appears on the TV screen even though the
speakers are connected properly. This is
because of the speakers’ specifications. In this
case, you can continue to use the receiver.
Tip
The displayed unit of distance is meter. You
can change the unit of distance to feet in
“Distance Unit” in the Speaker settings menu.
2 Press to select “Next”.
When “Save auto calibration (auto
speaker setup)?” appears on the TV
screen, you can select whether to confirm
the warning (“Yes”) or not (“No”).
Follow the instructions of the TV screen
when you select “Yes”.
For details on warning and error codes,
see “Message list after Auto Calibration
measurement” (page 49).
Tip
Press on the remote when “Please Press
ENTER.” appears on the TV screen.
Confirming/saving the
measurement results
continued