Filter
Top Products
111
GB
D:\NORM'S JOB\SONY HA\SO0056\STR-DA3500ES\CEL VERSION\GB\4144907431\01GB-
STRDA3500ESUC\100REM_GB.fm
masterpage: Right
STR-DA3500ES
4-144-907-43(1)
Using the Remote
1 Tune in the station that you
want to preset.
For details on the operation, see “Tuning
radio stations” (page 110).
2 Press SHIFT and then press
ENT/MEM.
“MEM” lights up on the display window
for a few seconds. Perform steps 3 and 4
before “MEM” disappears.
3 Press PRESET + or PRESET –
to select a preset number.
30 FM and 30 AM preset numbers are
available. If “MEM” lights off before you
select the preset number, start again from
step 2.
4 Press ENT/MEM.
If SHIFT indicator is light off before you
press ENT/MEM, press SHIFT.
The station is stored as the selected preset
number. If “MEM”disappears before you
press ENT/MEM, start again from step 2.
5 Repeat steps 1 to 4 to preset
another station.
Selecting a preset station
1
Press TUNER repeatedly to select the
FM or AM band.
2 Press PRESET + or PRESET –
repeatedly to select the preset station
you want.
You can also press SHIFT and then press
the numeric buttons to select the preset
station you want. Then, press to enter
the selection.
You can also press TUNING MODE on the
receiver repeatedly to select “PRESET”,
then turn TUNING +/– to select the preset
stations you want.
Operating each
component using the
multi function remote
You can control Sony or non-Sony
components you are using with the multi
function remote supplied with the receiver.
The remote is initially set to control Sony
components.
When you change the settings of the remote
according to the components you are using,
you can control non-Sony and other Sony
components that the remote is initially unable
control (page 113).
1 Press the input button that
matches the connected
component that you want to
operate.
2 Press the appropriated buttons
to use the function listed in the
table below.
Note
You may not be able to operate some functions for
the components you are using.
Presetting radio stations
Using the Remote
Operating the components
connected to the receiver