Sony 3-299-549-11(1) Home Theater System User Manual


 
Additional Information
105
GB
Operation
No sound or only a very low-level
sound is heard from the surround
speakers.
Check the speaker connections and settings (pages 23, 96).
Check the “DEC. MODE” setting (page 63).
Depending on the source, the effect of the surround speakers may be less
noticeable.
Wireless setting of the speaker is not correct.
A 2 channel source is being played.
The beginning of the sound is cut off. Set the Sound mode to other than “AUTO” (page 65).
Set the decoding mode to other than “A.F.D. MULTI” (page 63).
No sound is heard or sound is cut off. The S-AIR main unit and/or the surround amplifier is installed in a place
such as on a metal shelf.
Wireless LANs, a microwave (oven) and Bluetooth applications, etc. are
placed near the surround amplifier.
Move away the other components from the surround amplifier or turn off
the other components.
Symptom Remedy
Symptom Remedy
Radio stations cannot be tuned in. Check that the antenna (aerial) is connected securely. Adjust the antenna
(aerial) or connect an external antenna (aerial) if necessary.
The signal strength of the stations is too weak (when tuning in with
automatic tuning). Use direct tuning.
No stations have been preset or the preset stations have been cleared
(when tuning by scanning preset stations). Preset the stations (page 67).
Press DISPLAY so that the frequency appears in the front panel display.
The remote does not function. There are obstacles between the remote and the control unit.
The distance between the remote and the control unit is too far.
The remote is not pointed at the remote sensor on the control unit.
The batteries in the remote are weak.
A disc does not play. There is no disc inserted.
The disc is upside down.
Insert the disc with the playback side facing down.
The system cannot play CD-ROMs, etc. (page 7).
The region code on the DVD does not match the system.
Moisture has condensed inside the control unit and may cause damage to
the lenses. Remove the disc and leave the control unit turned on for about
half an hour.
The disc is not written properly.
The disc is dirty or flawed.
cont
i
nue
d