Filter
Top Products
[ Installation ]
53
Step 6: Set Your SIRIUS InV2’s FM transmitter to the same FM channel
a. Dock your SIRIUS receiver and turn its power ON. Wait for the Channel
Update to finish before pressing any buttons.
b. Press and hold the FM P
RESETS button. The InV2’s display will show the FM1
preset frequency (see Figure 31).
Note: FM1 is factory-set to 88.1MHz. This may not be the best frequency for
your area.
c. Press the Select button to select the FM1 preset.
d. Use the Channel UP/DOWN buttons to browse-through the different FM
channels until the channel you saved as a preset in Step 5 on page 52 appears
(see Figure 32).
e. Press the Select button. The new channel will now be the FM1 preset.
To listen to your SIRIUS radio, turn your SIRIUS radio ON, then turn your vehicle’s FM
radio ON and press the SIRIUS preset you set in Step 5, on page 52. You should hear
your SIRIUS radio through your vehicle’s FM radio.
FM Presets
Button
Select
Button
Channel
UP/DOWN
Buttons
Figure 31
Figure 32