Filter
Top Products
Sanyo CRSR-10 User Guide Sanyo CRSR-10 User Guide
27
26
Antenna Aiming
When using the home antenna (included) or the
optional BMBX-10 Boombox docking station
indoors, it is important to position the antenna in
an acceptable location (See the BMBX-10
installation guides for more information on the
Boombox).
1. In the Menu Options screen, use the CHANNEL
Button to highlight “Antenna Aiming”. Press the
SELECT Button to select.
2. Two 10 segment horizontal bar graphs will be
displayed ( SAT and TER) with a “-” sign to the left
and a “+” sign to the right. SAT indicates a
satellite signal and TER indicates a terrestrial
signal – if available.
3. It is best to position the antenna on a window sill
with a clear view of the sky.
4. Adjust the antenna for maximum performance by
positioning the antenna where the above signals
are the strongest. To exit this function, press the
SELECT Button or the MENU button.
Changing the Lock/Unlock Code
The first time the Lock/Unlock function is accessed,
the user must enter the default lock code. The
default lock code is “0000”. This code can be
maintained or changed. To change the default lock
code, perform the following procedure while in the
“Menu Options” List mode:
1. Use the CHANNEL Button to highlight “Lock
Options”. Press the SELECT Button to select.
2. Select “Edit Code” (top left) from the Lock
Options Menu and press the SELECT Button to
select.
3. Enter the default code “0000”.
4. The “Enter Code” prompt will appear. Enter your
new four digit code using the 0-9 number buttons.
(top right) You will then be prompted to confirm the
new code by entering your code again.
5. The lock code is now changed.
Note: You can use this same method to Edit the
code once it is changed from the default.
Audio Level
The audio output of the CRSR-10 can be adjusted
to fine-tune the audio signal level for maximum
performance. This is important when using the
optional BMBX-10 Boombox Docking Station. To
change the Audio Level, perform the following
procedure while in the “Menu Options” List mode:
1. Use the CHANNEL Button to highlight the “Audio
Level ”. Press the SELECT Button to select.
2. Use the CHANNEL Button to adjust to the desired
audio output level. A 10 segment horizontal bar
graph is displayed with a “-” sign to the left and a
“+” sign to the right. To select and exit this
function, press the SELECT or MENU Button.
Audio Level
-+
Antenna Aiming
TERTER
TER
l
SATSAT
SAT
--
--
++
++