Filter
Top Products
Sanyo CRSR-10 User Guide Sanyo CRSR-10 User Guide
Menu Display Options
To enter the Menu Options page, press and release
the MENU Button. The “Menu Options” list will
appear on the display (below).
Using the CHANNEL Button, highlight the option
you wish to adjust and press the SELECT Button.
The following options are available:
Activating the Song (S-Seek) Alert
1. Press and hold the MEMO button for 2 seconds to
enter the S-Seek Mode.
2. Press and Release the SELECT Button. A pop-up
screen displaying two selectable options -
“Delete” and “S-Seek” will appear (below left).
3. Use the CHANNEL Button to highlight the “S-
Seek” option.
4. Press and release the SELECT Button and an S-
Seek confirmation screen will appear. Select the
“ On“” option using the CHANNEL Button and
press the SELECT Button to confirm (below right).
Each time the CRSR-10 is turned on, it
automatically searches the incoming signal to
determine if a match exists between the signal
and the currently saved information stored in the
CRSR-10 memory. If one or more matches are
found, a pop-up screen momentarily appears for
2-seconds and displays “S-Seek”.
An audible beep tone will be heard indicating that
a match has been found. The display then reverts
to the S-Seek Alert screen which displays the
current matches. You can now select the Artist/
Song Title that you wish to listen to. No stored
match alert is provided for the currently selected
channel. To ensure that no duplicate entries are
stored in memory, the CRSR-10 will check the
stored input data to ensure the information about
to be stored is not already in memory.
• If one or more matches are found, a display list
appears (below), and allows you to scroll
through the list of songs using the CHANNEL
Button. Once a song is found, it can be selected
by pressing the SELECT Button, and the display
will revert to either selected display modes.
• If a selection is not chosen within 10 seconds
after the last action, the screen will revert to the
previously selected display and tuning mode.
Sirius ID
Displays your 12-digit Sirius ID (SID) number. The
SID is unique to every CRSR-10 and is required to
activate your service. It is recommended that you
write this number in the space provided on the last
page of this user guide. No adjustments are
allowed in this mode. To exit this option, press the
SELECT Button or MENU Button.
21
20
Note: If a button is not pressed within 10 seconds,
the Receiver will exit the “Menu Options” function
and reverts back to the Default Screen display.
Sirius ID
Display Settings
FM Transmitter
Channel Add/Skip
Lock Options
Audio Level
Antenna Aiming
Memory Options
Time Features
Factory Default