Filter
Top Products
45
It is important to perform speaker confi guration prior to using the
surround sound decoder. It is possible to receive multi-channel surround
sound without a center speaker, but for best results with Dolby Pro Logic
IIx and Dolby Digital decoding, at least 5 speakers (Front Left, Center,
Front Right, Surround Left, and Surround Right) should be used.
Note: When no action is taken for 5 seconds, the Speaker Setup mode will
be cancelled.
Size of Speakers
1. Press STANDBY/ON to turn the unit on.
2. Press SURROUND and select a surround mode for 6.1 channel
(such as DOLBY PRO LOGIC IIx MUSIC or MOVIE, etc).
3. Press SET UP. SPEAKER SIZE appears on the front panel’s display.
4. Press ENTER. FRONT SPEAKER appears on the front panel’s display.
5. Press ENTER. FRONT LARGE or FRONT SMALL appears on the
display.
LARGE: Set to LARGE if your speaker can handle full frequency
range (including lower than 100 Hz). For example, if your speaker’s
frequency response is 20 Hz-20 kHz, use LARGE. The complete
frequency range for the channel you are setting will be output
from the speaker.
SMALL: Set to SMALL if your speaker cannot handle lower than
120 Hz. For example, if your speaker’s frequency response is 120
Hz-20 kHz, use SMALL. Frequencies of the channel you are setting
SURROUND
STANDBY
ENTER