Filter
Top Products
MOON Stargate Processor
Full Function Remote Control Programming
Volume Punch Through
You can set the audio volume controls (VOL !, VOL " and MUTE) to operate on any of the eight (8)
Device modes.
Step 1:
Press the Device and MUTE buttons, simultaneously.
Step 2:
Press the VOL ! button.
Step 3:
Press the AVC device button to select the type of volume you wish to operate in that mode.
Example:
If you wish to have the AVC volume operate in the DVD mode, press the DVD Device button in
Step 1. above and the AVC Device button in Step 3.
Programming a Macro Sequence
Macro buttons (M1, M2, M3, M4 and POWER) can send out a sequence of up to ten (10) commands by
pressing one (1) button. Macros can be programmed in both the AVC and SAT modes, and they can
be accessed in other modes. If a macro is programmed in the AVC mode, that macro can also be
accessed in the CD, DVD, and AUX modes. If a macro is programmed in the SAT mode, that macro
can also be accessed in the TV, VCR and CBL modes. Macros can also be used to turn on or turn off
up to five (5) components or select favorite channels, etc.
Step 1:
Press a Device button (AVC or SAT) and the MUTE button simultaneously. Hold both buttons
until the red light under the Device button turns on.
Step 2:
Press one of the five macro buttons (M1, M2, M3, M4 or Power) that you wish to program.
The red light under the Device button will blink once for each subsequent button press.
Step 3:
Press up to 10 commands you would like to include in the macro sequence. Pressing a Device
button to change modes is counted as one command. Note: The Power On/Off command, for
devices other than the AVC receiver, is programmed into a macro using the MUTE button.
Step 4:
Press the CH ! button to store the commands. The red Status LED and the Device button will
blink twice to confirm the program and then turn off.
To erase a macro sequence follow the above steps 1, 2 & 4 without going through step 3.
____________________________________________________________________________________
Full Function Remote Control Programming 17