Filter
Top Products
MOON Stargate Processor
Full Function Remote Control Operation
The supplied remote control (figure 9) can operate up to eight (8)
different components and is programmable via a learning mode. The
eight (8) buttons located on the top 2 rows allow you to select the
component you wish to operate. Please refer to the next section
“Remote Control Programming” for instructions on how to manually
program this remote control.
To operate the Stargate with this remote control you must first press
the button labeled
‘AVC’ on the top left corner.
POWER: Puts the Stargate into “Standby” mode. This button cannot
turn the unit on; you must use one of the input selection buttons
located further down on the remote (i.e.
DVD, LD, VCR1, VCR2, etc.).
MUTE: Places the unit in Mute mode – no output volume.
T/V: Toggle between NTSC and PAL video system (for OSD only).
CH ! and CH ": Seek up/down AM/FM tuner frequency.
VOL ! and VOL ": Adjusts output volume up/down.
GUIDE: The “Status Display” appears on screen.
MENU: The on screen “Setup” Menu appears on screen.
EXIT: Exit from the on screen Menus.
SELECT ! # " $ cursors used for SYSTEM SETUP functions
DVD, LD, VCR1, VCR2, SAT, AUX, CD, TV, TUNER, TAPE and 7.1:
Selects a source input and turns unit on from “Standby” mode.
SURR: Places the processor into Surround mode.
STEREO: Places the processor into Stereo mode.
MUSIC 7: Places the processor into 7.1 music mode.
MODE: Toggles between Dolby Surround Pro Logic
®
II Music, Dolby
Surround Pro Logic
®
II Movie, DTS Neo:6
®
Music and DTS
NEO:6
®
Cinema modes.
BASS: Sets the bass trim for the currently selected input.
1 thru 10: AM/FM Tuner Presets. To save the current radio station as
a ‘Preset’, press and hold one of the 10 preset buttons until
the sound mutes for approximately ½ second.
ZONE: Activate remote for ‘Zone 2’ function control (i.e. volume, seek,
input source selection, mute, off)
LIGHT: Turns on the remote’s backlighting (will auto shut off).
Figure 9 SHIFT: Toggle between AM and FM on the tuner.
This remote control uses four (4) AAA batteries which are included.
____________________________________________________________________________________
Full Function Remote Control Operation 14