Sherwood V-903 CD Player User Manual


 
26
ENGLISH
CHANGING THE VIDEO SIGNAL FORMAT
Depending on the countries, this DVD player conforms to either the NTSC color system for U.S.A, Canada, etc., or the PAL
for Europe, Australia, China, etc.
If the color system of this DVD player is different from that of your TV monitor and the discs to be played, the screen may be
somewhat hard to see or the picture quality may be poor.
Only in this case, change the video signal format to another.
(For details about the video signal format of your TV monitor or the discs, refer to the operating instruction of your TV or the
discs jacket.)
In the stop mode, press the NTSC/PAL button.
Each time this button is pressed, the video signal format
changes as follows:
󳂵 MULTI 󳂵 NTSC 󳂵 PAL
The MULTI is compatible with both NTSC and PAL formats.
CHANGING THE COMPONENT VIDEO OUTPUT SIGNAL
Only during playback of DVD Video on this unit, the COMPONENT VIDEO OUTs of this unit can be capable of outputting
either conventional interlacing video signal or progressively scanned video signal(that can reproduce high-density pictures
with less flicker).
When the COMPONENT VIDEO OUTs of this unit are connected to the COMPONENT VIDEO INs of TV or projector, etc.,
depending on whether the video signal system of your TV or projector, etc. supports the conventional interlacing(simply
called interlaced) video signals or the progressively scanned(simply called progressive) video signals(that can reproduce
high-density pictures with less flicker), you should select the corresponding video signal.
Notes:
When you select the PROGRESSIVE TV, the S-VIDEO and (composite) VIDEO OUTs of this unit cannot output the normal
video signals. Therefore, it cause the picture to break up and shake.
When the progressive video signals are input into the non-progressive COMPONENT VIDEO INs of your TV, etc., the
picture may not be shown normally, too.
Therefore, when the progressive COMPONENT VIDEO INs of TV is not connected to, you should select INTERLACE TV.
In the stop mode, press the PROGRESSIVE SCAN button.
Each time this button is pressed, the component video
output signal changes and INTERLACE TV or
PROGRESSIVE TV is displayed on the TV screen.
RC
NTSC/PAL
RC
P.SCAN