Filter
Top Products
ENGLISH
DIGI LINK III System Remote controls
8
SCAN
DISPLAY
1
2
3
4
5
6
7
89
0
A< >B
D.TIME
S.MODE
PRESET
USER
AD JUST T.TONE
FILE
SCAN
AB
POWER
SLEEP
P.
SYS
INTRO
TAPE1
AUX/TV
VCR1
CENTER LEVEL
MASTER VOLUME
REAR LEVEL
CD
TUNER
REPEAT
CD
DISPLAY
T.MON
DVD PHONO
DECK SEL
DISC
FUNC
DECKEQ
MUTE
TAPE2
MON
LDP
SUBWOOFER LEVEL
REMOTE CONTROL UNIT RM-RV-N925
PRESET SCAN BUTTONSLEEP BUTTON
POWER BUTTON
SYSTEM DISPLAY BUTTON
PRESET – for selecting equalizer pattern.
USER – for adjusting equalizer pattern as desired.
FILE – for selecting desired equalizer pattern in the
preset or in the user mode.
DISPLAY – for selecting equalizer display.
T.MON – for monitoring the sound of recording or
playback on tape deck.
■ TAPE DECK SECTION
DISC(CD changer only) – for disc selection
– to begin play
– for pausing play
– to stop play or to clear a program
, – for skipping backward or forward
REPEAT A < > B – to play a specific passage
repeatedly
INTRO SCAN – to preview each track only
for 10 sec
■ CD PLAYER SECTION
SURROUND MODE BUTTON
DELAY TIME BUTTON
MUTE BUTTON
INPUT SELECTOR BUTTONS
■ EQUALIZER SECTION
TEST TONE BUTTON
ADJUST BUTTON
MASTER VOLUME/CENTER LEVEL/REAR
LEVEL / SUBWOOFER LEVEL UP/DOWN
( / ) BUTTONS
In the standby mode, when pressing a input
selector button, the unit is turned on automatically
and the desired input source is selected.
NUMERIC BUTTONS – for selecting preset stations
or entering frequency directly in tuner mode.
For selecting a track or a disc in CD mode.
When selecting a disc, select disc No. (1~5) within 2
sec. after pressing the DISC button.
DECK SELECTOR A, B – for selecting deck A or B
, – to begin forward or reverse side playback
– for pausing playback or recording
– to stop playback or recording
, – to wind tape reverse or forward
– for recording
Note : In the United States, the R-925 is shipped with a Universal Illuminated Pre-programmed Remote Control(RNC-100).
When using this manual for instructions that require pressing buttons on the remote control, it will be necessary to
press different buttons than those shown here.
Please see the owner`s manual supplied with the remote for the corresponding buttons.
You can remotely control not only this receiver but also Sherwood compatible components bearing the DIGI LINKor
logo.
For system remote control operation, first make the DIGI LINK connections.
In the DIGI LINK remote control system, if pressing PLAY,etc. on CD player or tape deck, CD or TAPE 2 MONITOR
is selected automatically without selecting the input source and then PLAY,etc. starts.
In this case,to listen to TAPE 1, switch off the TAPE 2 MONITOR and select the TAPE 1.
Notes:
Some functions for CD player, tape deck or equalizer may not be available.
For details about functions, refer to the operating instructions of each component.