Filter
Top Products
Troubleshooting Guide
23
7
PROBLEM POSSIBLE CAUSE REMEDY
No power
No sound
No sound from the rear
speakers
No sound from the center
speaker
Stations cannot be received
Preset stations cannot be
received
Poor FM reception
Continuous hissing noise
during FM reception,
especially when a stereo
broadcast is received.
Cnotinuous or intermittent
hissing noise during AM
reception, especially at night.
Remote control unit does not
operate.
Other system components do
not react to remote control
commands.
The AC input cord is disconnected.
Poor connection at AC wall outlet or the
outlet is inactive.
The speaker cords are disconnected.
The master volume is adjusted too low.
The MUTE button is pressed to ON.
Speakers are not switched on.
The digital input is not selected correctly
Incorrect selection of input source.
Incorrect connections between the
components.
Surround mode is switched off.
Master volume and rear level are too
low.
Monaural source is used.
Dolby 3 Stereo mode is selected.
Dolby DIGITAL(AC-3), Dolby Pro Logic
or Dolby 3 Stereo mode is not selected.
Master volume and center level are too
low.
No antenna is connected.
The desired station frequency is not
tuned in.
Antenna is in wrong position.
An incorrect station frequency has been
memorized.
The memorized stations are cleared.
No antenna is connected.
The antenna is not positioned for the
best reception.
Weak signals.
Noise is caused by motors, fluorescent
lamps or lightning, etc.
Batteries are not loaded or exhausted.
The remote sensor is obstructed.
DIGI LINK connections are not made
properly.
Connect cord securely.
Check the outlet using a lamp or another
appliance.
Check the speaker connections.
Adjust the master volume.
Press the MUTE button to cancel the
muting effect.
Press the SPEAKER ON/OFF switch to
ON.
Select the digital input correctly.
Select the desired input source correctly.
Make connections correctly.
Select a surround mode.
Adjust master volume and rear level.
Select a stereo or surround source.
Select the desired surround mode.
Select the desired surround mode.
Adjust master volume and rear level.
Connect an antenna.
Tune in the desired station frequency.
Move antenna and retry turning.
Memorize the correct station frequency.
Memorize the stations again.
Connect an antenna.
Change the position of the antenna.
Change the position of the antenna.
Install an otudoor antenna.
Keep the receiver away from noise sources.
Install an outdoor AM antenna.
Replace the batteries.
Remove the obstacle.
Make proper DIGI LINK connections.
If a fault occurs, run through the table below before taking your receiver for repair.
If the fault persists, attempt to solve it by switching the receiver off and on again. If this fails to resolve the situation,
consult your dealer. Under no circumstances should you repair the receiver yourself as this will invalidate the guarantee!
ENGLISH