Sherwood R-925 Stereo Receiver User Manual


 
ENGLISH
MEMO / ENTER
MEMO / ENTER
SPEAKER
MODE
SPEAKER
MODE
Memorize the desired subwoofer mode
while it flickers.
6
14
Memorize the desired center speaker mode
while it flickers.
4
󳀏The desired center speaker mode is memorized and
then it becomes the subwoofer mode.
󳀏If the center speaker display goes off, repeat again
from the above step 2.
󳀏Each time this button is pressed,the subwoofer
mode changes and flickers as follows;
YES : When using a subwoofer.
NO : When not using a subwoofer.
󳀏If the subwoofer display goes off, repeat again from
the above step 2.
󳀏Each time this button is pressed briefly, the setting
of the center speaker or the subwoofer is displayed.
Select the desired subwoofer mode.
5
Checking the speaker setting
󳂸
Adjusting the speaker settings
Press the SPEAKER MODE button for more than 2
seconds to enter the center speaker mode.
2
Select the desired center speaker mode.
3
󳀏Adjusting the setting of the center speaker and the
subwoofer connected.
󳀏In the THEATER, HALL, STADIUM, CHURCH or
normal stereo mode, it will become the subwoofer
mode directly.
󳀏Each time this button is pressed, the center speaker mode
changes and flickers as follows;
: When using a relatively large center speaker.
: When using a relatively small center speaker.
: When not using a center speaker.
󳀏In the Dolby 3 Stereo mode, the NONE mode can not be
selected.
SPEAKER
MODE
SPEAKER
MODE
LARGE
SMALL
NONE