Filter
Top Products
• If the parameter display disappears, start from the
step 1 again.
At the desired parameter, adjust it as desired.
2
Repeat the above steps 1 and 2 to adjust
other parameters.
3
28
To cancel the surround mode for stereo operation
• Then the stereo mode is selected.
• To cancel the stereo mode, select the desired surround mode with using the DSP MODE
(<) or (>) button.
or
SURROUND MODE
STEREO
• Each time this button is pressed, the parameter changes and is displayed for several seconds as follows;
Panorama mode(“PANO”, default value : OFF)
This mode extends the front stereo image to include the surround speakers for an exciting “wraparound”
effect with side wall imaging. Select “OFF” or “ON”.
Center width control(“C-WID”, default value : 0)
This adjusts the center image so it may be heard only from the center speaker, only from the left/right
speakers as a phantom image, or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
Dimension control(“DIMEN”, default value : 0)
This gradually adjusts the soundfield either towards the front or towards the rear. The control can be set in 7
steps from -4 to +2.
• When selecting the Dolby Pro Logic II Music mode, you can adjust the various surround parameters for optimum
surround effect.
Adjusting the Dolby Pro Logic II Music parameters
Press the PL II MUSIC PARAMETER button to select the desired parameter.
1
or
PL
II
MUSIC
PARAMETER
or
ADJUST
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
T/V
1
2 3 4
8765
9
M1 M2 M3
0
+10
MACRO
STEREO
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
T/V
1
2 3 4
8765
9
M1 M2 M3
0
+10+10
MACRO
PL II PARA.
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
T/V
1
2 3 4
8765
9
M1 M2 M3
0
+10
MACRO
ADJUST
<, >