Filter
Top Products
T/VT/V
1
2 3 4
8765
9
M1M1 M2M2 M3M3
0
+10+10
MACROMACRO
7m
30
30
REMOTE
SENSOR
PTY SELECTDISPLAY
EON TA
SEARCH
EON PTY
SURROUND MODEINPUT SELECTOR
VIDEOAUDIO STEREO7CH DIRECT AUTO
MASTER VOLUME
ON/STANDBY
POWER
STANDBY
ON/OFF
TUNING/PRESETADJUST
PHONES
CHANNEL
SELECTOR
VIDEO L
-
AUDIO
-
R
VIDEO 3
BANDFM MODET/P MODETONE MODE
SPEAKER
SETUP
DYNAMIC
RANGE
MEMO/ENTERCINEMA EQ
ON/OFF
SPEAKER
DSP MODE
DIGITAL
INPUTS
PL
II
MUSIC
PARAMETER
15
LOADING BATTERIES
REMOTE CONTROL OPERATION RANGE
1 2
• Use the remote control unit within a range of
about 7 meters (23 feet) and angles of up to 30
degrees aiming at the remote sensor.
OPERATING COMPONENTS WITH REMOTE CONTROL
• Remove the batteries when they are not used for a
long time.
• Do not use the rechargeable batteries(Ni-Cd type).
• Be sure to use alkaline batteries.
Remove the cover.
Load two batteries(“AAA” size) matching
the polarity.
1
Enter the setup code for each component
other than this receiver you wish to
control. For details, refer to “Entering a
setup code” on page 16.
2
Turn on the component you want to
operate.
3
Press the DEVICE button on the remote
control corresponding to the component
you wish to operate.
4
Aim the remote control at the REMOTE
SENSOR of the component you wish to
control and press the button corresponding
to the operation you want.
• When operating a Sherwood CD player or tape deck
using digi link system remote control, aim the remote
control at the REMOTE SENSOR of this receiver.
However, to operate a Sherwood DVD player, aim at
the REMOTE SENSOR of the corresponding
component.
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within
several minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared.
Should this happen, you should memorize them again.
+
+