Filter
Top Products
18
Programming a macro function
Note:
You should press the corresponding DEVICE buttons
before pressing each operation button.
Example) When playing a DVD on the DVD player
connected to VIDEO 2 jacks of this receiver.
1. Press “AUDIO” button to control this receiver.
2. Press “POWER” button to turn this receiver on.
3. Press “AUDIO” button to control this receiver.
4. Press “VIDEO 2(7)” button to select the desired
input source.
5. Press “DVD” button to control the DVD player.
6. Press “POWER” button to turn the DVD player on.
7. Press “DVD” button to control the DVD player.
8. Press “
” button to start playback.
Press the operation buttons you want to
program in order.
2
Press and hold down both “ENTER” button
and one of three NUMERIC buttons
(“1”~“3”) corresponding to “M1”~“M3”
buttons for more than 1 second.
1
• If the programming is performed successfully, the
LED will flicker twice.
To remove a macro program
• When removing a macro program, perform the above
steps 1 and 3, but ignore the step 2.
To change a macro program
• When a new macro program is stored into a MACRO
button with performing the above steps 1 to 3, the
previous macro program is cleared from the memory
of the MACRO button.
Press “ENTER” button.
3
• The macro function enables you to program a series
of button operations(up to 10) on this remote control
into a single button.
• You can store up to three separate macro command
sequences into “M1”, “M2” and “M3” buttons.
Operating a macro function
Notes:
• The codes programmed into a MACRO button will
be transmitted at an interval of 0.5 seconds.
However, some components may not be able to
complete one operation in 0.5 seconds and may miss
the next code.
In this case, the macro function cannot control the
corresponding components correctly.
• Be sure to use the remote control within the remote
control operation range of the components.
• Depending on the operation status of the
components, etc., the macro function cannot control
the corresponding components correctly.
• Aim the remote control at the REMOTE SENSORs
of the components to be controlled and press the
MACRO button you want.
Example) When pressing “M1” button.
• If the macro mode is entered, the LED will flicker
once.
AUD AUD
7
VIDEO2VIDEO2
DVD DVD
POWER ONPOWER ON
POWER ONPOWER ON
Example) When programming a series of button
operations into “M1” button.
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
T/V
1
2 3 4
8765
9
M1 M2 M3
0
+10
MACRO
ENTER
+
1
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
ENTER
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
T/V
1
234
8765
9
M1M1 M2M2 M3M3
0
+10+10
MACROMACRO
M1