Filter
Top Products
27
ENJOYING SURROUND SOUND
Depending on the input digital signal format, select the desired decoding mode.
1
• Each time the AUTO button is pressed, the decoding
mode changes as follows :
IN-AUTO : The input digital signal format(DTS, Dolby
Digital or PCM(2 channel stereo), etc.) used
by the selected digital input source is detected
automatically to perform the necessary
decoding process for optimum surround mode.
IN-DTS : The DTS signal processing is performed only
when DTS signals are input.
IN-PCM : The PCM signal processing is performed only
when PCM signals are input.
or
SURROUND MO
AUTO
Select the desired surround mode.
2
• Each time the DSP MODE (<) or (>) button is pressed, the surround mode changes depending on the input signal
format and the selected decoding mode as follows :
Notes :
• Only when the digital input is selected as signal input for the input sources except TUNER, TAPE and AUX, the
decoding mode can be selected.
• Noise may be generated at the beginning of playback and while searching during DTS playback in the IN-AUTO
mode. In this case, try playing in the IN-DTS mode.
or
SURROUND MODE
DSP MODE
Signal format being input Selected decoding mode Selectable surround mode
Dolby Digital EX 6.1 channel sources IN-AUTO mode DOLBY DIGITAL EX, DOLBY VIRTUAL
Dolby Digital 5.1 channel sources IN-AUTO mode DOLBY DIGITAL, DOLBY VIRTUAL
Dolby Digital 2-channel IN-AUTO mode PL II MOVIE, PL II MUSIC,
sources PRO LOGIC, DOLBY VIRTUAL
PCM(2 channel) sources IN-AUTO, IN-PCM mode PL II MOVIE, PL II MUSIC, PRO LOGIC,
Analog stereo sources DOLBY VIRTUAL, NEO 6 CINEMA, NEO 6
MUSIC, THEATER, HALL, MATRIX
DTS sources IN-AUTO, IN-DTS mode corresponding DTS mode
• When the analog input is selected as signal input and analog stereo signals are input, you can select the desired of
these above surround modes, too.
• However, when DTS signals are input in the IN-AUTO or IN-DTS mode, the corresponding DTS mode will be
selected regardless of using the DSP MODE (<) or (>) button.
Notes:
• When the selected decoding mode is not matched to the input signal format, the “DIGITAL” indicator flickers and
no sound is heard. Therefore, be sure to select the required decoding mode and the available surround mode
according to the input signal format.
• When the 7 CH DIRECT is selected as an input source, the decoding and surround modes cannot be selected.
• When the digital signals are not inputted, the desired surround mode cannot be selected.
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
T/V
1
2 3 4
8765
9
M1 M2 M3
0
+10
MACRO
AUTO
T/V
1
234
8765
9
M1 M2 M3
0
+10
MACRO
T/V
1
2 3 4
8765
9
M1 M2 M3
0
+10
MACRO
DSP <, >