Filter
Top Products
CD-ESg00
CD-ES99
32
• Headphones
• Before plugging h_or unplugging the headphones, reduce the vol-
ume.
• Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and are between I6 ohms and 50 ohms impedance. The recom-
mended impedance is 32 ohms.
• Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved bythe owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
• General
Symptom Possible cause
• The clock is not set to the • Did a power failure occur? Reset
correct time. the clock. (Refer to page I5.)
• When a button is pressed, • Set the unit to the power stand-
the unit does not respond, by mode and then turn it back on.
• If the unit stillmalfunctions, reset
it. (Refer to page 33.)
• No sound is heard. • Is the volume level set to "0"?
• Are the headphones connected?
• Are the speaker wires discon-
nected?
• CD player
Symptom Possible cause
• Playback does not start. • Is the disc loaded upside down?
• Playback stops in the mid- • Does the disc satisfy the stan-
die or is not performed dards?
properly. • Is the disc distorted or
scratched?
• Ptayback sounds are • Istheunitlocatednearexcessive
skipped, or stopped inthe vibrations?
middle of a track. • Is the disc very dirty?
• Has condensation formed inside
the unit?