Filter
Top Products
Setting the clock oo-EsgOOoo_Es99
In this example, the clock is set for the 12-hour (AM I2:00) display.
Press the ON/STAND-BY button to turn the power on.
2 Press the CLOCK/TIMER button.
3 Within 10 seconds, press the _ _ or _* P,_ button to se-
lect "CLOCK", and press the MEMORY/SET button.
I l ..........
_ i r F _ r i r F t
4 Press the I_ _ or _,_ _t button to select 12-hour or 24-
hour display and then press the MEMONY/SET button.
"AM I2:00 ..... _ The 12-hour display witl appear.
(AM I2:00- PM 1"I:59)
"AM 0:00" -_ The 12-hour display will appear.
(AM 0:00- PM I1:59)
%:00" _ The 24-hour display witl appear.
(O:0O - 23:59)
5 Press the P4_,,_ or _'_ _ button to adjust the hour and then
press the MEMORY/SET button.
6
Press the t_ _ or I_- _ button once to advance the time by I
hour. Hold it down to advance continuously.
Press the I_1 _ or _- I_,l button to adjust the minutes and
then press the MEMORY/SET button.
L _ f_ L
Press the I_1 _1_1or _ _l button once to advance the time by I
minute, Hold it down to change the time in 5-minute intervals.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button.
The time display wilt appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the I_,_ _ or _- _ button to disptay the time.
The time display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time dis-
play when the AC power supply is restored after a power failure or
unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" is not
appear in step 3, step 4 (for selecting the 12-hour or 24-hour dis-
play) wil! be skipped.
To change the 12-hour or 24-hour display:
I Clear all the programmed contents. [Refer to "Clearing al! the
memory (reset)" on page 33 for details.]
2 Perform "Setting the clock" from step 1.
Note:
The clock can also be set with the remote control.
15