Filter
Top Products
E-5
General control
Press the ON/STAND-BY button to turn the power on.
To dim the display brightness, press the DIMMER button on
the remote control.
If you turn off and on the main unit with the volume set to 27
or higher, the volume starts at 16 and fades in to the last set
level.
Press VOL +/- to increase or decrease the volume.
The volume is muted temporarily when pressing the MUTE
button on the remote control. Press again to restore the
volume.
When you press any of the following buttons, the unit turns on.
●
iPod, CD/USB, AUDIO IN, TUNER, NETWORK on the
remote control: Selected function is activated.
●
/ button on the main unit: The unit turns on and
playback of the last function will start (CD, TUNER, USB,
iPod, AUDIO IN, NETWORK)
The main unit will enter the stand-by mode (when iPad, iPod
or iPhone is not connected) after 15 minutes of inactivity
during:
iPod: Not docked.
Audio In: No detection of input signal.
CD: In the stop mode or no disc.
USB: In the stop mode or no media.
Note:
However, if iPod or iPhone is docked, the unit will begin
charging.
“Charge Mode” will be displayed.
During stand-by mode, when you select DK-KP95PH speaker
through AirPlay icon on your AirPlay device, the unit will
automatically power on to Network function and stream the
music from your AirPlay device.
This condition applies when:
● The AirPlay network has previously been set up
between the unit and your AirPlay device.
● Set the Network Stand-by mode to ON. (refer page 8)
During other function (CD, TUNER, USB, iPod, Audio In),
when you select DK-KP95PH speaker through AirPlay
icon on your AirPlay device, the unit will automatically
switch to Network function and stream the music from your
AirPlay device.
This condition applies when:
● The AirPlay network has previously been set up
between the unit and your AirPlay device.
When the power is first turned on, the unit will enter the extra
bass mode which emphasises the bass frequencies, and
“X-BASS” indicator will appear. To cancel the extra bass
mode, press the X-BASS button on the remote control.
1
Press the BASS/TREBLE button to select “Bass”.
2
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the bass. “X-BASS” indicator will disappear.
1
Press the BASS/TREBLE button to select “Treble”.
2
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the treble. “X-BASS” indicator will disappear.
When the FUNCTION button on main unit is pressed, the
current function will change to different mode. Press the
FUNCTION button repeatedly to select desired function.
Note:
The backup function will protect the memorised function
mode for a few hours should there be a power failure or the
AC power lead becomes disconnected.
■ To turn the power on
After use:
Press the ON/STAND-BY button to enter the power stand-
by mode.
■ Display brightness control
■ Volume auto fade-in
■ Volume control
■ Muting
■ Direct key power on function
■ Auto power off function
Dimmer 1
Dimmer 2
Dimmer off
(Display is dim).
(Display is bright).
(Display gets dimmer).
■ Auto power on
■ AirPlay auto switch
■ X-Bass control
■ Bass control
■ Treble control
■ Function
- 5 ↔ - 4
........
↔ + 4 ↔ + 5
- 5 ↔ - 4
........
↔ + 4 ↔ + 5
FM STEREO
FM MONO
USB
iPod
Audio In
AM
CD
NETWORK