Filter
Top Products
AN-PR1000_EN.fm06/3/14
TINSEA127AWZZ
16
AN-PR1000_EN.fm06/3/14
AN-PR1000H
TINSEA127AWZZ
Preparation for Use
Audio connections to TVs, DVD
players, VCRs, etc. (continued)
Connecting a digital tuner, etc.
Connect to the digital tuner, etc. using an optical digital audio cable or a coaxial digital
audio cable.
Note:
When connecting with an optical digital cable, set the digital output of the digital tuner
to PCM. Refer to the operation manual of the digital tuner.
AC power connection
Connecting the AC power lead
After checking all the connections have been made correctly, connect the AC power
lead to the AC power input socket, then to the wall socket.
Notes:
Never use a power lead other than the one supplied. Otherwise, a malfunction or
an accident may occur.
Unplug the AC power lead from the wall socket if the unit will not be in use for a
prolonged period of time.
To turn the power on
Press the ON/STAND-BY button.
If the power does not turn on, check whether the power lead is plugged in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
Note:
After the unit enters the power stand-by mode, wait a few seconds to turn on again.
To the TV (video)
Main unit
Optical digital audio cable
(commercially available)
To OPTICAL
input socket
To optical digital
audio output socket
Coaxial digital
audio cable
(commercially
available)
To coaxial
digital audio
output socket
To COAXIAL
input socket
Audio signal
Audio signal
Wall socket
(AC 220 V- 240 V,
50 Hz)