Filter
Top Products
Using the transmitter
15
Carrying out an Easy Setup Sync or a Sync function
The following assumes that you are using the Easy Setup Sync function for setting up a multi-
channel system. You can also you the Easy Setup Sync function for establishing a transmis-
sion link between one transmitter and one receiver.
Setting Transferred parameters
“Balance” Current balance setting
(“−15”/“+15”)
“Squelch” Current squelch setting
(“Off”, “5 dB” ... “25 dB”)
“Mode” Current audio mode setting
(“Stereo”/“Focus”)
“High boost” Current treble boost setting
(“flat”/“High boost”)
“Auto Lock” Current lock mode setting
(“active”/“inactive”)
“Limiter” Current limiter setting
(“−18 dB”, “−12 dB”, “−6dB”, “Off”)
When carrying out the Sync function, the transmitter’s current frequency bank
and channel setting is automatically transferred to the receiver via the infra-red
interface.
Easy Setup Sync Sync
̈ Switch your rack-mount transmitters
and your diversity receiver on.
̈ Switch your rack-mount transmitter
and your diversity receiver on.
̈ On all transmitters, call up the “Easy
Setup” menu item.
The text “Easy Setup Sync” and the
icon appear on the display panels of the
transmitters.
The RF signal of the transmitters is auto-
matically deactivated.
̈ Press the button » on the trans-
mitter.
The icon appears on the display
panels of the transmitter.
̈ Use your EK 300 IEM G3 diversity receiver
to perform a frequency preset scan and
select a frequency bank with a sufficient
number of unused channels (see the
instruction manual of the receiver).
–