Filter
Top Products
Using the transmitter
14
To activate the RF signal:
Monitoring the audio signal via headphones
You can monitor the audio signal via the headphone output.
̈ Set the headphone volume control · to the minimum position.
̈ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output ³.
̈ Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
Synchronizing transmitters and receivers via the infra-red
interface
Easy Setup Sync function (EK 300 IEM G3 -> SR 300 IEM G3)
Once you have performed a frequency preset scan with your EK 300 IEM G3 diversity receiver
(see the instruction manual of the receiver), you can use the Easy Setup Sync function to
transfer unused frequency presets from the receiver to the transmitters via the infra-red
interface. The diversity receiver transfers the first unused channel from the current frequency
bank to the first transmitter and the next unused channel to the second transmitter and
so on.
Sync function (SR 300 IEM G3 -> EK 300 IEM G3)
On the other hand, you can use the Sync function to adjust settings for your EK 300 IEM G3
diversity receiver directly on your SR 300 IEM G3 rack-mount transmitter and transfer theses
settings to the receiver via the infra-red interface.
Via the “Sync Settings” submenu, you can adjust the parameters listed below and activate or
deactivate their transfer to the receiver (see page 20).
Use this function to prepare a transmitter for use during live operation without
causing interference to existing transmission links.
̈ Briefly press the STANDBY button ¶.
“RF Mute Off” appears on the display panel.
̈ Press the jog dial.
The transmission icon ቦ is displayed again.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
̈ Set the headphone volume control · to the minimum position before putting the head-
phones on.
³ ·