Filter
Top Products
Using the operating menu
20
Overview of the operating menu
When the standard display is shown on the display panel, you can get into the main menu by
pressing the jog dial. The extended menu “Advanced Menu” and the other menus can be
accessed via the corresponding menu items.
For more detailed information on the operating menu, refer to the instruction
manual of the SR 300 IEM G3. This instruction manual can be downloaded from
the SR 300 IEM G3 product page at www.sennheiser.com.
Sensitivity
Easy Setup
Mode
Frequency Preset
Name
Equalizer
AutoLock
Advanced
Exit
Main menu
“Menu”
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Extended menu
“Advanced Menu”
AF Peak
RF Mute
Exit
“Warnings”
Balance
Squelch
Mode
High Boost
Auto Lock
Limiter
Exit
“Sync Settings”
Display Function of the menu item
Main menu “Menu”
Sensitivity Adjusts the input sensitivity
Easy Setup Deactivates the RF signal and activates Easy Setup Sync (see page 21)
Mode Selects mono or stereo operation
Frequency Preset Changes the frequency bank and the channel
Name Enters the transmitter name
Equalizer Changes the frequency response of the output signal using a graphic equalizer
AutoLock Activates/deactivates the automatic lock mode
Advanced Calls up the extended menu “Advanced Menu”
Exit Exits the operating menu and returns to the standard display
Extended menu “Advanced Menu”
Tune Sets the transmission frequencies for the frequency banks “U1” to “U6”
Special function: Sets a channel and a transmission frequency for the frequency banks “U1” to
“U6”:
̈ Select this menu item and call it up by pressing the jog dial ² until the channel selection
appears.
Sync Settings Adjusts the parameters to be transferred to the receiver and activates/deactivates the transfer
RF Power Adjusts the transmission power
Warnings Activates/deactivates the warning messages
LCD Contrast Adjusts the contrast of the display panel
Reset Resets the transmitter