Filter
Top Products
Using the transmitter
13
Using the transmitter
To establish a transmission link, proceed as follows:
1. Switch the transmitter on (see below).
2. Switch the receiver on (see the instruction manual of the receiver).
The transmission link is established.
If you cannot establish a transmission link between transmitter and receiver:
̈ Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
̈ If necessary, read the chapter “If a problem occurs ...” on page 23.
Switching the transmitter on/off
To switch the transmitter on (online operation):
To switch the transmitter to standby mode:
̈ If necessary, deactivate the lock mode (see page 18).
To completely switch the transmitter off:
̈ Disconnect the transmitter from the mains by unplugging the mains unit from the wall
socket.
The backlighting of the STANDBY button ¶ goes off.
To switch the transmitter on and to deactivate the RF signal on switch-on (offline operation):
It is vital to observe the notes on frequency selection on page 21.
ᕧ
̈ Press the STANDBY button ¶.
The transmitter switches on and the standard display appears.
The transmitter transmits an RF signal and the transmission icon ቦ is displayed
You can switch the transmitter on and deactivate the RF signal on switch-on.
For more information, see below.
̈ Keep the STANDBY button ¶ pressed until “OFF” appears on the display panel.
The display panel switches off.
When in the operating menu, pressing the STANDBY button ¶ will cancel your entry
(ESC function) and return you to the standard display.
The STANDBY button ¶ is backlit in red both during operation and in standby mode.
̈ Press the STANDBY button ¶ until “RF Mute On?” appears on the display panel.
̈ Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit
an RF signal. The transmission icon ቦ
is not displayed
.