Filter
Top Products
Putting the transmitter into operation
12
Connecting transmitters in a network
You can connect several transmitters in a network. The transmitters are remote controlled via
a PC running the “Wireless Systems Manager” (WSM) software. This software will assist in
the quick and safe configuration of multi-channel systems.
̈ Connect a standard network cable (at least Cat 5) to the LAN socket ¸ of the transmitter.
̈ Connect your transmitters to an Ethernet switch.
̈ Connect a PC to the Ethernet switch.
When a transmitter is properly connected to the Ethernet switch or the PC, the yellow
LED µ at the rear of the transmitter lights up.
For further information on network operation, refer to page 22.
Connecting the mains unit
Only use the supplied mains unit. It is designed for the transmitter and ensures safe
operation.
̈ Insert the yellow connector of the NT 2-3 mains unit into the yellow socket ¾ of the
transmitter.
̈ Pass the cable of the mains unit through the cable grip º.
̈ Slide the supplied country adapter ƿ onto the mains unit ƾ.
̈ Plug the mains unit ƾ into a wall socket.
The STANDBY button is backlit in red.
The “Wireless Systems Manager” (WSM) software can be downloaded from the
corresponding product page on our website at www.sennheiser.com.
L(I)
+22dBu
MAX
Loop Ou
BAL
0682
FREQ Range-D 780-822 MHz
DESIGNED AND MADE IN GERMANY FMO
Stereo Transmitter SR 30
IDENT NO 627925
SER NO 2518100155
IC 2099A-G3SREK
¸µ
ƿ
¾
º
ƾ
The AC 3 antenna combiner incorporates DC distribution to enable simultaneous
powering of up to four transmitters via its BNC sockets. These transmitters do not
require their individual power supply (see also page 11).