Filter
Top Products
33
Adjustment tips for the operating menu
̈ Change to the setting mode of the “Clock” menu.
The current setting starts flashing.
̈ Turn the jog dial 7 to select the desired sampling rate.
̈ Press the save button 8.
The selected sampling rate is stored. The display changes to the selec-
tion mode of the operating menu.
The receiver’s audio outputs have a latency which depends on the
sampling rate set in the “Clock” menu. The below table shows these
latency times as well the distances
*
to which they approximately corre-
spond.
Configuring the audio outputs of the EM 3732 COM-II
The EM 3732 COM-II twin receiver has two audio outputs per receiver:
1. the audio outputs AF Out 1 M and AF Out 2 K,
2. the command outputs Command 1 L and Command 2 J.
These audio outputs can be switched on and off via a button on the trans-
mitter – provided that the transmitter is also equipped with the command
function (a separate power pack with command button is available for the
SKM 5200 transmitter).
48
44.1
48
88.2
96
Ext.
kHz
esc
save
sync
digital audio
processing
sync
D
EV
M
H
z
777.005
U.01
BANK
CH
COM
AF
HD
P
8
7
If you select “Ext.” even though no external word clock signal is
available at the BNC socket for word clock input H (e.g. because
the external word clock generator is not connected or switched
off), the display for external word clock synchronization B starts
flashing and the last set sampling rate remains active.
* “distance” describes the listening distance to the sound source.
Audio output Sampling rate
kHz
Latency
ms
Corresponds to a distance of
approx. ... cm*
Analog 44.1 / 88.2 1.8 60
Analog 48 / 96 1.7 55
Digital 44.1 1.9 65
Digital 48 1.7 55
Digital 88.2 1.8 60
Digital 96 1.7 55
Comm
3
Command
3
l
ock
96
Mor
e