Sennheiser I EM 3732-II Command Stereo Receiver User Manual


 
21
Using the receiver
̈ Position the transmitter’s infra-red interface at a max. distance of 5 cm
in front of the infra-red interface (sync) A.
The transfer starts automatically. During the transfer, the two blue
LEDs in the infra-red interface (sync) A flash and the backlighting of
the sync button 9 flashes green.
After successful completion of the synchronization, the two blue
LEDs in the infra-red interface (sync) A stop flashing and the
sync button 9 is backlit in green. The receiver’s frequency and name
are now also set on the transmitter and the transmission link is ready
for operation.
If an error occurred during synchronization (e.g. the transmitter is
too far away from the receiver), the two blue LEDs in the infra-red
interface (sync) A stop flashing and the sync button 9 is backlit in
red.
Identifying receivers using the “Wireless Systems
Manager” software (identifying function)
In multi-channel operation, it can be useful to identify the individual chan-
nels of the receivers via the “Wireless Systems Manager” software. The
identifying function shows you which channel is assigned to which
receiver.
̈ Start the identifying function as described in the instruction manual of
the “Wireless Systems Manger” software.
Identified” appears on the status display of the identified receiver:
After 60 seconds, the text disappears and the current status display is
shown again.
To change to the current status display before the end of the 60 seconds:
̈ Press the esc button 6.
esc
save
sync
digital audio
processing
sync
5cm
<
300
100
30
10
1
5
10
PEA
µV
RF
%
A B
SKM 5200-II
The infra-red interface of the SKM 5200-II hand-held transmitter is
located at the left-hand margin of the display. Position the trans-
mitter’s infra-red interface precisely in front of the receiver’s infra-
red interface (sync) A.
Identified
esc
save
clock
sync
M
H
z
6.000
.01
BANK
CH
6
COM
AF
HD
P