Filter
Top Products
-E35-
6. Setting progressive mode
1) In “Display” screen, press [5] to select “Progressive”.
2) Press [ENTER]. The submenu appears.
Note:
If “Progressive” is not selected...
First, press [z/ON] to turn the power off.
Then, confirm that the VIDEO OUT SELECT switch is
set to the COMPONENT position. (See page E15.)
Next, press [z/ON] again to turn the power on, and press
[SETUP] to open the setup screen.
3) Press [5] or [4] to select the progressive mode (“On” or
“Off”).
4) Press [ENTER]. The submenu is set.
5) Press [4] to skip back to the setup screen or press
[SETUP] to quit the setup screen.
Note:
To reset to the initial setting “TV System: NTSC” and
“Progressive: Off”...
In the no disc mode, press [ON SCREEN] for at least 5 seconds
even if “ ” appears.