Sanyo DWM-4500 Home Theater System User Manual


 
-E12-
Using the Rear Speaker in Wireless Mode
1. Set the SPEAKER switch of the rear speaker to the INTERNAL
position.
Changing the frequency setting
If noise (or skipping sound) is heard when using rear speaker in
wireless mode, change the setting of the FREQUENCY switch
on both sub-woofer and rear speaker.
Match the number on both sub-woofer and rear speaker.
It may improve the sounds.
The following four frequencies are available.
FREQUENCY switch
1 (914.1 MHz)
2 (914.5 MHz)
3 (914.9 MHz)
4 (915.3 MHz)
Using the Rear Speaker in Wired Mode
Because the rear speaker is the wireless type, it is not necessary
to connect the assistant speaker cable under normal connections.
If noise is caused to the rear speaker when used in wireless
mode, change the setting of the FREQUENCY switch on both
sub-woofer and rear speaker (Refer to the left column).
If noise is still caused, turn the power off first and connect the
rear speaker to the sub-woofer using the supplied assistant
speaker cable. In this case, the audio signal is sent to the rear
speaker through the assistant speaker cable.
Sub-woofer (powered speaker)
Assistant speaker cable
Note:
Adjust the distances between the sub-woofer and the rear speaker
to be suitable shorter than approx. 23 feet cord length.
If Using the External Speaker (Not Supplied)
Instead of the Rear Speaker...
1. Connect the external speaker (4 , more than 50 Watts for
each speaker, not supplied) to the EXTERNAL SPEAKERS
terminal.
Front left speaker
Front right speaker
Center speaker
External rear
left speaker
(not supplied)
Sub-woofer
External rear
right speaker
(not supplied)
2. Pull out gently the antenna vertically.
• Try not to hold, bend, or twist the antenna.
Sub-woofer
(Powered speaker)
Rear speaker
(Powered speaker)
CAUTION:
Keep it out of reach of young children who might damage
it.
3. Set the FREQUENCY switch to “1”, “2”, “3” or “4”.
Match the number on both sub-woofer and rear speaker.
2. Set the SPEAKER switch to the EXTERNAL position.
3. Place the external speaker as shown in figure.
1
2
Sub-woofer
(Powered speaker)
External rear
right speaker
(not supplied)
External rear
left speaker
(not supplied)
Rear speaker
(Powered speaker)
Rear speaker
(Powered speaker)
Rear speaker (Powered
speaker)
To REAR OUT
jack
To REAR IN
jack