Filter
Top Products
32
ST2S TUNER PROGRAMMING
ST2 TUNER SETUP MENU
Press Select
button to select
Sirius Tuner
BANK #
BANK
NAME
SAVE
CHANGES?
Sirius Setup Menu
Bank Name Procedure
Selects
character
Selects
character
position
Repeat
for each
character
in name
MEM
NAME
Procedure
BANK
NAME
Procedure
Sirius
Setup
Menu
FACTORY
INIT
Procedure
CONTROLLR
ID
Procedure
SYSTEM
INFO
Procedure
DIAGNOSTICS
Procedure
SOURCE
NUM
Procedure
FACTORY
INIT
Procedure
UPDATE
FIRMW
Procedure
SYSTEM
INFO
Procedure
TUNER
SETUP
Menu
Chassis
Setup
Menu
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Controller ID (SIRIUS)
The Controller ID procedure is used to identify
the controller(s) that the SIRIUS tuner will
respond to.
Note: For the SIRIUS module that is installed in
the ST2S chassis, “All Controllers” will be the
default setting.
Diagnostics (SIRIUS)
The Diagnostics procedure is for factory use only.
Factory Initialization (SIRIUS)
The Factory Initialization procedure allows the
erasure of all programmed settings of the SIRIUS
tuner and returns them to the factory default set-
tings.
1. Enter the Setup Menu by pressing and holding
the SELECT button.
2. TUNER SETUP appears. Press MODE/BAND.
3. MEMORY NAME appears. Press MEM
Up/Down until FACTORY INIT appears on the tuner.