Russound ST2S Stereo System User Manual


 
UNO-LRC1 Remote Control Operation
Turning the unit on
The tuner is power managed by the CAV6.6 or other
RNET-enabled controller. If the tuner is in standby
mode, any button press of the UNO-LRC1 will bring
the tuner out of standby mode when used with the
UNO keypad.
Selecting the desired tuner
To select a tuner, push and choose the source
number preassigned to Tuner 1 (SIRIUS) or Tuner 2
(AM/FM), or use the UNO numeric source inputs at
the bottom of the UNO-LRC1.
Selecting the desired band (AM/FM only)
Push to toggle between AM/FM reception.
Selecting a Mode (SIRIUS)
Push , or to toggle between SIR-
IUS operating modes.
Exiting a Mode (SIRIUS)
Press or to exit SIRIUS operating mode
menu.
Signal Strength mode (SIRIUS)
Press and hold and release. The display shows
the signal strength rating. To exit press .
Selecting the desired frequency or channel
Use the Channel and or and
for manual tuning. To move quickly through the
channels, press and hold the button for more than
1.5 seconds. To directly select a station or channel,
enter the three- or four-digit channel or frequency
Frequency Seek (AM/FM only)
The SEEK function is performed by pressing and
releasing the Select or or . To seek
higher frequency station press . Press for
lower frequencies. Tuning begins at the current fre-
quency, seeks upward (or downward) and stops at the
next tuned station. Pushing or again con-
tinues the SEEK function. Once the highest frequency
is reached, the tuner continues SEEK mode at the
lowest frequency.
Frequency Scan (AM/FM only)
To scan, press and hold then release . The
tuner scans through tuned stations with a 5-second
preview before moving to the next station. To end
scanning, press again.
Selecting a Bank
To select a bank, press and hold for bank up
or for bank down.
Recalling a Memory Preset
Press and or and to scroll
through a loop of all the memory presets for the cur-
rently selected bank. Only configured presets will be
displayed.
Mute
Press the button to mute/unmute the tuner
audio output.
ST2S OPERATION
UNO-LRC1 REMOTE CONTROL WITH CAV6.6
26