Filter
Top Products
22
ST2S OPERATION
ST2-RC REMOTE CONTROL
ST2-RC Remote Control Operation
The ST2-RC remote control is the only means of
remote operation of the ST2S in a non--RNET system.
The ST2S front panel displays information for the
tuner that is receiving commands from the ST2-RC.
However, the ST2-RC commands do not change
which tuner is playing; that is done through the sys-
tem’s source selection.
Turning the unit on/off
To switch the ST2 tuner in or out of standby mode,
push or any other button except TUNER 1 or
TUNER 2.
Selecting the desired tuner
To control a tuner, push or . When
pressed, these buttons will be backlit green for Tuner
1 (SIRIUS) and amber for Tuner 2 (AM/FM). Each time
a tuner is selected, the next button press will refresh
the display with the current station or preset for that
tuner,
and all subsequent button presses and memory
preset entries will be associated with that selected
tuner.
Selecting the desired band (AM/FM only)
Push to switch between AM and FM reception.
Selecting the desired frequency or channel
Use and for manual tuning. To move quickly
through the stations or channels, press and hold
either of the Tune buttons for more than 1.5 seconds.
To directly select a station or channel, press ,
and enter the two- or three-digit SIRIUS channel num-
ber, or the three- or four-digit station frequency
(1071 for 107.1, etc.). European regions use five-
digit station frequencies.
Selecting a mode (SIRIUS)
Push to select an SIRIUS operating mode.
Exiting a mode (SIRIUS)
Push to exit the SIRIUS operating mode selection
menu.
Frequency Seek (AM/FM only)
The SEEK function is performed by pressing and
releasing to seek lower frequencies or for
higher frequencies. SEEK tuning begins at the current
frequency, seeks upward and stops at the next tuned
station. Pushing continues the SEEK function.
Once the highest frequency is reached, the tuner con-
tinues in SEEK mode at the lowest frequency.
Selecting Stereo or Mono Output
(AM/FM only)
Press to toggle between stereo and mono mode.
STEREO or MONO appears briefly on the screen when
selecting mode. Normal operation is in stereo mode.
On a preset, the stereo/mono setting is saved for
that preset.
Selecting Distant or Local Reception
(AM/FM only)
Press to toggle between Distant and Local
mode. DISTANT or LOCAL appears briefly on the
screen when selecting mode. Normal operation is in
Distant mode.
Recalling a Memory Preset
To recall a memory preset, select the desired tuner,
press and enter the desired bank number
(1-6), then press and enter the desired preset
number (1 to 6). The memory presets can also be
accessed by using and to scroll through all
presets for the selected bank.
Saving Favorites
The remote control stores two “favorites” (similar to
memory presets) per tuner. These are set simply by
selecting either Tuner 1 or Tuner 2, setting the
desired frequency and pressing and holding or
until “FAV1 (2) saved” appears on the tuner.
Stored Favorites are then recalled by pressing either
or .
FAV 2
FAV 1
FAV 2
FAV 1
M
EM
MEM
M
E
M
B
A
N
K
LOC/
DX
ST/
MONO
ST/
MONO
OK
TUNE
TUNE
TUNE
AM/FM
TUNER 2TUNER 1
PWR