Filter
Top Products
24
ST2S OPERATION
UNO-S2 KEYPAD CONTROLS WITH CAV6.6
CAV6.6-UNO-S2 Keypad Operation
NOTE: To control the ST2 Tuner through the
UNO-S2 keypad, the tuner must be configured
as a source using the CAV6.6 programming
steps.
Turning the unit on
The tuner is power managed by the CAV6.6 or other
RNET-enabled controller. If the tuner is in standby
mode, any button press of the UNO-S2 keypad will
bring the tuner out of standby mode.
Selecting the desired tuner
On the UNO-S2 keypad, press to select
either Tuner 1 (SIRIUS) or Tuner 2 (AM/FM) by
choosing the tuner’s preassigned source num-
ber.
Selecting the desired band (AM/FM only)
Push to toggle between AM band and FM
band reception.
Selecting a Mode (SIRIUS)
Push to toggle between SIRIUS modes.
Exiting a Mode (SIRIUS)
Press
and release
until EXIT is displayed to
exit SIRIUS mode selection menu.
Selecting the desired frequency or channel
Use and for manual tuning or channel
selection. The frequency or channel will appear
on the keypad and the active tuner. To move
quickly through the channels, press and hold
either or for more than 1.5 seconds
.
Frequency Seek (AM/FM only)
A press on will seek the next higher tune-
able station. If a tuneable station is not found,
end the SEEK function by pressing again.
Frequency Scan (AM/FM only)
To scan, press and hold then release . The
tuner scans through tuned stations with a 5-sec-
ond preview before moving to the next station.
To end scanning, press again.
Signal Strength Mode (SIRIUS)
To check SIRIUS signal strength, press and hold
then release. The display shows the signal
strength rating. To exit, press again.
Selecting a Bank
To select a bank, press and hold for bank
up or for bank down. The bank’s name will
be temporarily displayed on the UNO-S2.
Recalling a Memory Preset
Press and to scroll through the memo-
ry presets for the selected bank. This procedure
will step through all of the presets in the current
bank, then loop back to start at the first one.
Only configured presets will be displayed.
Mute
Press to mute/unmute the tuner audio output.