Filter
Top Products
29
ST2S TUNER PROGRAMMING
ST2 TUNER SETUP MENU
Press and Hold
Select button
ST2 Chassis Setup Procedures
This
Procedure
returns the
ST2 Tuner
to its
Factory
settings
SOURCE
NUM
Procedure
FACTORY
INIT
Procedure
UPDATE
FIRMW
Procedure
SYSTEM
INFO
Procedure
HOLD
MODE
After update
cycle Power
Start
Update
Cycle Power
TUNER
#
SOURCE
NUM
TUNER
SETUP
Menu
Chassis
Setup
Menu
Are you sure
YES
NO
Please wait
Cycle Power
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
1. Enter the Setup Menu by pressing and holding
the SELECT button.
2. TUNER SETUP appears. Press MEM Up/Down
until UPDATE FIRMW appears on the tuner.
3. Press MODE/BAND to enter the UPDATE FIRMW
menu.
4. “Hold BAND” appears on the tuner.
5. While pressing and holding MODE/BAND,
“After update cycle power” appears on the tuner
display.
6. When “Start Update” appears on the tuner dis-
play, start the update program. “Finished”
appears on the computer screen when complete.
7. Cycle power to the tuner.
Factory Initialization (Chassis)
The Factory Initialization procedure allows the
erasure of all programmed settings and returns
them to the factory default settings.
1. Enter the Setup Menu by pressing and holding
the SELECT button.
2. TUNER SETUP appears. Press MEM Up/Down
until FACTORY INIT appears on the tuner.
3. Press MODE/BAND to enter the FACTORY INIT
menu.
4. “Are you sure” appears on the tuner. Using the
Tune Up/Down buttons, view the “Yes” and “No”
selections.
5. Press MODE/BAND to select. A “No” selection
returns to the top of the Factory Init menu. A
“Yes” begins the initialization.
6. “Please wait” appears on the tuner during the
process and “Cycle Power” appears when com-
plete.
7. Cycle power on the ST2S tuner.