Filter
Top Products
23
UNO-LRC1 Remote Control Operation
Turning the unit on
The tuner is power managed by the CAV6.6 or
other RNET-enabled controller. If the tuner is in
standby mode, any button press of the UNO-
LRC1 will bring the tuner out of standby mode
when used with the UNO keypad.
Selecting the desired tuner
To select a tuner, push and choose the source
number preassigned to Tuner 1 (XM1) or Tuner 2
(XM2), or use the UNO numeric source inputs at the
bottom of the UNO-LRC1.
Selecting an XM Mode
Push , , ,or to toggle
between XM operating modes.
Exiting an XM Mode
Press or to exit XM operating mode menu.
Signal Strength mode
Press and hold and release. The display shows
the signal strength rating. To exit press .
Selecting the desired channel
Use the Channel and or and
for manual tuning. To move quickly through the
channels, press and hold the button for more than
1.5 seconds. To directly select a channel, enter the
three- or four-digit channel number.
Selecting a Bank
To select a bank, press and hold for bank up
or for bank down.
Recalling a Memory Preset
Press and or and to scroll
through a loop of all the memory presets for the cur-
rently selected bank. Only configured presets will be
displayed.
Mute
Press the button to mute/unmute the tuner
audio output.
ST2-XM2 OPERATION
UNO-LRC1 REMOTE CONTROL WITH CAV6.6/CAM6.6