Filter
Top Products
19
ST2-XM2 OPERATION
ST2-RC REMOTE CONTROL
ST2-RC Remote Control Operation
The ST2-RC remote control is the only means of
remote operation of the ST2-XM2 in a non--RNET sys-
tem. The ST2-XM2 front panel displays information for
the tuner that is receiving commands from the ST2-
RC. However, the ST2-RC commands do not change
which tuner is playing; that is done through the sys-
tem’s source selection.
Turning the unit on/off
To switch the ST2 tuner in or out of standby mode,
push or any other button except TUNER 1 or
TUNER 2.
Selecting the desired tuner
To control a tuner, push or . When
pressed, these buttons will be backlit green for Tuner
1 (XM1) and amber for Tuner 2 (XM2). Each time a
tuner is selected the display will refresh with the cur-
rent station or preset for that tuner,
and all subse-
quent button presses and memory preset entries will
be associated with that selected tuner.
Selecting the desired channel
Use and for manual tuning. To move quickly
through the channels, press and hold either of the
Tune buttons for more than 1.5 seconds.
To directly select a channel, press , and enter
the two- or three-digit XM channel number.
Selecting an XM mode
Push to select an XM operating mode.
Exiting an XM mode
Push to exit the XM operating mode selection
menu.
Recalling a Memory Preset
To recall a memory preset, select the desired tuner,
press and enter the desired bank number
(1-6), then press and enter the desired preset
number (1 to 6). The memory presets can also be
accessed by using and to scroll through all
presets for the selected bank.
Saving Favorites
The remote control stores two “favorites” (similar to
memory presets) per tuner. These are set simply by
selecting either Tuner 1 or Tuner 2, setting the
desired frequency and pressing and holding or
until “FAV1 (2) saved” appears on the tuner.
Stored Favorites are then recalled by pressing either
or .
FAV 2
FAV 1
FAV 2
FAV 1
M
EM
MEM
M
E
M
B
A
N
K
ST/
MONO
OK
TUNE
TUNE
TUNE
TUNER 2TUNER 1
PWR