Filter
Top Products
18
Front Panel Operation
Turning the unit on
To turn the unit on, push the On/Off button up on the
front panel. Pushing the On/Off button down turns the
tuner off.
Selecting the desired tuner
From the front panel, use to toggle between the
XM tuners. A backlight shows behind the selected
label XM1 (green) or XM2 (amber) to indicate the
active tuner. In addition, the LCD panel is also backlit
green for Tuner 1 and amber for Tuner 2. Each time a
tuner is selected the display will refresh with the cur-
rent station or preset, and all subsequent memory
preset entries will be associated with that selected
tuner.
Selecting an XM mode
Push to select an XM operating mode.
Exiting an XM mode
Push to exit the XM mode selection menu.
Signal Strength mode
Press and hold and release. The display shows
the signal strength rating. To exit press .
Selecting the desired channel
Press and release and for manual tuning.
Bank/Memory Presets
Each tuner has six banks of preset memory settings,
and each bank holds six presets for a total of 36 pos-
sible presets for each tuner (72 total presets).
Presets are associated with the tuner that is selected
at the time the preset is saved.
Memory Preset programming
From the front panel, perform these steps:
1. Select a tuner using .
2. Use to choose from one of six banks (1-6).
3. Tune to the desired channel.
4. Push the desired memory preset (M1 through M6)
button for more than 2 seconds. When the memory
preset is saved, the appropriate preset number (M1
through M6) and SAVED appears on the LCD. The
selected station setting reappears and the sound
resumes after the button is released.
Recalling a Memory Preset
To recall a memory preset, use to select the
desired bank, then press the desired preset button
(M1 to M6). In addition to direct selection, the memo-
ry presets can be accessed by using and to
scroll through all presets for the bank selected.
Backup and Restore
Once all of the tuner settings are completed, it may
be advisable to create a backup of the programmed
settings for future use. The backup will then be avail-
able in case tuner settings need to be restored. The
“RNET Backup Utility” is available through the
Document Center at
www.russound.com
. Also
required are a DB9 male-to-female cable and laptop
or desktop PC.
ST2-XM2 OPERATION
FRONT PANEL CONTROLS