Filter
Top Products
7
Russound CA4 System Installation Manual
KEYpAd USAGE & FEATURES
Setting Loudness
Enter the User Menu.1.
Press the source button to select Source 3 (lower left) for Loudness. The 2.
window will blink.
Press the volume up button to turn the feature ON, or the volume down 3.
button to turn it OFF. The far right hand volume LED will indicate ON and
the far left hand volume LED will indicate OFF.
Either press the Source button to go to the next option or exit the User 4.
Menu by a 3-second press of the source button or a time-out.
Loudness Setting Mode
Source Group Setting Mode
Keypad Functions
Power ON/OFF: A press and release of the power, source or volume up /
down buttons will turn the keypad ON. A press and release of the power
button will turn the keypad and the backlighting OFF. Note: If there are other
keypads ON in the system the power button will remain lit.
Volume Adjustment: Upon initial powering of the keypad, the volume will
automatically ramp up to the factory set turn-on volume level. Pressing the
volume up or down buttons will change the volume accordingly. Volume
levels will be indicated by the LEDs above the volume up button. Hold the
buttons to ramp the volume up or down accordingly.
Source Selection: A press and release of the source button will cycle
through the sources. The selected source will be backlit on the keypad.
All ON: A press and hold of the power button (3-seconds) while the zone is
already in the ON state will turn all keypads ON (if enabled to respond). The
volume LEDs will light up from the center and ramp outward. Usage Note:
If initiating an All ON command, all other powered zones will automatically
be placed into a Party Mode as non-Masters and will not have independent
source control. The initiating keypad is the Master and will need to be turned
o to discontinue the Party Mode before source control can be available for
other zones.
All OFF: A press and hold of the power button (3-seconds) while the zone is
in the OFF state will turn all keypads OFF. The volume LEDs will light up from
the center and ramp outward. The backlighting on all keypads will turn o
and the system will be in Standby mode.
Press and release Source
button to cycle through
sources
Press Volume Up or
Down buttons to
change volume
Source 2
Source 1
Source 4
Source 3
Power
Volume Indicators
Press and release of the
Source, Volume Up, Volume
Down, or Power buttons will
turn the keypad ON
Setting Source Grouping
Enter the User Menu.1.
Press and release the source button to cycle to and select Source 4 (lower 2.
right). The window will blink.
Pressing the volume up button will activate the feature and pressing the 3.
volume down button deactivates the feature. The far right hand volume
LED will indicate ON and the far left hand volume LED will indicate OFF.
Either press the Source button to go to the next option or exit the User 4.
Menu by a 3-second press of the source button or a time-out.
Go to another keypad that is connected to the 5. same controller and repeat
the procedure so that these zones will be linked and listening to the same
source. Any source changes on any of the linked keypads will be tracked
and updated on all source linked keypads. Volume control remains
independent as well as zone ON and OFF. Only zones connected to the
same controller can be source grouped.